Table of Contents

1 INTRODUCTION
2 SCOPE
3 REFERENCED PUBLICATIONS
4 DEFINITIONS
5 GENERAL
   5.1 Safety Precautions
   5.2 Equipment Precautions
6 SELECTION AND INSTALLATION OF HYBRID TANK MEASUREMENT
   SYSTEM EQUIPMENT
   6.1 General
   6.2 Automatic Tank Gauge (ATG)
   6.3 HTMS Pressure Sensor(s)
   6.4 Automatic Tank Thermometer (ATT)
   6.5 Hybrid Processor
   6.6 Optional Sensors
7 ACCURACY EFFECTS OF HTMS COMPONENTS AND INSTALLATION
   7.1 Accuracy Effects of the ATG
   7.2 Accuracy Effects of the Pressure Sensor(s)
   7.3 Accuracy Effects of the ATT
8 HTMS MEASUREMENTS AND CALCULATIONS
   8.1 HTMS Mode 1
   8.2 HTMS Mode 2
9 COMMISSIONING AND INITIAL FIELD CALIBRATION
   9.1 Initial Preparation
   9.2 Initial HTMS Component Calibrations
   9.3 Verification of Hybrid Processor Calculations
   9.4 Initial Field Verification of HTMS
10 REGULAR VERIFICATION OF HTMS
   10.1 General
   10.2 Objectives
   10.3 Adjustment During Regular Verification
   10.4 Regular Verification of HTMS in Volume-based Custody
        Transfer Applications
   10.5 Regular Verification of HTMS in Mass-based Custody
        Transfer Applications
   10.6 Handling Out-of-Tolerance Situations During Regular
        Verification of HTMS in Custody Transfer Application
   10.7 Regular Verification of HTMS in Inventory Control
        Application
APPENDIX A - CALCULATION OVERVIEW
APPENDIX B - MEASUREMENT ACCURACY
APPENDIX C - ILLUSTRATIVE EXAMPLE

Abstract

Describes selection, installation, commissioning, calibration and verification of Hybrid Tank Measurement Systems (HTMSs) for the measurement of level, static mass, observed and standard volume, and observed and reference density in tanks storing petroleum and petroleum products.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	American Petroleum Institute
ProductNote	Reconfirmed 2005
Pages
ISBN