Table of Contents

1 -  AS 3533.4.3-2007 AMUSEMENT RIDES AND DEVICES - SPECIFIC REQUIREMENTS-ROLLER COASTERS
4 -  PREFACE
5 -  CONTENTS
6 -  FOREWORD
7 -  1 SCOPE
7 -  2 APPLICATION
7 -  3 REFERENCED DOCUMENTS
8 -  4 DEFINITIONS
8 -  4.1 Competent person
8 -  4.2 Risk assessment
8 -  4.3 Risk management
8 -  4.4 Roller coaster
8 -  5 DESIGN AND CONSTRUCTION
8 -  5.1 General
8 -  5.2 Vehicles
9 -  5.3 Track
10 -  5.4 Elevators (lifts)-Machinery
10 -  5.5 Embarkation and disembarkation stations
11 -  5.6 Anti-roll-back systems
11 -  5.7 Block zone system (anti-collision system)
11 -  5.8 Braking systems and brakes
12 -  5.9 Control systems
13 -  6 OPERATION AND MAINTENANCE
13 -  6.1 General
13 -  6.2 Operation
13 -  6.3 Modification
13 -  6.4 Inspections
13 -  6.4.1 General
13 -  6.4.2 Inspections for steel track roller coasters
16 -  6.4.3 Inspections for wooden roller coasters
19 -  6.4.4 Brakes
19 -  6.4.5 Electrical systems
20 -  6.4.6 Corrosion
20 -  6.4.7 Non-destructive testing (NDT) of single point critical failure components
20 -  6.5 Maintenance
20 -  6.5.1 General
20 -  6.5.2 Corrosion
20 -  6.5.3 Repairs
21 -  APPENDIX A - HIGH ACCELERATION AREAS AND INVERTED ELEMENTS
21 -  A1 SCOPE
21 -  A2 INVERTED ELEMENTS
21 -  A3 ACCELEROMETER RUN RESULTS
21 -  A4 COMMON LOCATIONS OF HIGH ACCELERATION AREAS

Abstract

Sets out requirements and guidance specific to the design, construction, operation and maintenance of roller coasters. It is intended for use in conjunction with AS 3533.1, AS 3533.2 and AS 3533.3.

Scope

This Standard sets out requirements and guidance for the design, construction, operation and maintenance of roller coasters.
NOTE: This Standard refers to roller coasters whose main characteristic is that the motion of the vehicle is produced mainly by an exchange between potential and kinetic energy, and where an initial store of potential energy is provided by an elevating, launch or self-driven system. Coasters falling into this category may employ trains of interconnected vehicles, an individual vehicle or a number of individual vehicles, and may incorporate features in their track design which cause inversions (loops) and high accelerations. They may travel in both forward and reverse directions.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	ME-051
Supersedes	DR 06288