Abstract

Specifies the requirements for welded carbon and stainless steel cylinders with one longitudinal joint, and two circumferential joints, of water capacity not less than 150 kg nor more than 500 kg.

RECONFIRMATION NOTICE
Technical Committee ME-002 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 22 May 2017.
The following are represented on Technical Committee ME-002:
Australasian Fire and Emergency Service Authorities Council
Australia New Zealand Industrial Gas Association
Australian Chamber of Commerce and Industry
Engineers Australia
Environmental Protection Authority New Zealand
Fire Protection Association Australia
Gas Energy Australia
Gas Technical Regulators Committee
International Accreditation New Zealand
National Association of Testing Authorities Australia
SafeWork NSW
The Australian Gas Association
Welding Technology Institute of Australia
Worksafe New Zealand
WorkSafe Victoria

Scope

This Standard specifies requirements for welded carbon and stainless steel cylinders with one longitudinal joint, and two circumferential joints, of water capacity not less than 150 kg nor more than 500 kg, which have test pressures from 1750 kPa to 7000 kPa, and are intended for the storage and transport of compressed gases in accordance with AS 2030.1.
NOTES:
1 A gas cylinder manufactured by welding but which includes any brazing of or on the pressure-retaining portions is for the purpose of this Standard considered to be a brazed gas cylinder.
2 Other Australian Standards for brazed and welded gas cylinders are AS 2469 and AS 2470.
3 Appendix A lists the suggested minimum information that should be supplied by the purchaser when ordering gas cylinders to this Standard.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 07/07/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 07/07/2017
Pages
ISBN
Committee	ME-002
Supersedes	DR 06248 AS 3577-1999