Table of Contents

1 -  AS/NZS 1301.457s:2006 METHODS OF TEST FOR PULP AND PAPER - DETERMINATION OF MOISTURE CONTENT IN PAPER, BOARD AND PULPS
7 -  1 SCOPE
7 -  2 NORMATIVE REFERENCES
7 -  3 METHODS
7 -  3.1 Oven-drying method
7 -  3.2 Distillation method
8 -  4 DEFINITIONS
8 -  4.1 Moisture content on as received basis
8 -  4.2 Moisture content on an oven-dry basis
8 -  5 APPARATUS
8 -  5.1 Oven-drying method
8 -  5.1.1 Balance
8 -  5.1.2 Containers
8 -  5.1.3 Drying oven
8 -  5.1.4 Desiccator
8 -  5.2 Distillation method
8 -  5.2.1 Dean and Stark apparatus
9 -  5.2.2 Reagent
10 -  6 PROCEDURES
10 -  6.1 Oven-drying method
10 -  6.2 Distillation method
10 -  7 CALCULATION
10 -  7.1 Oven-drying method
11 -  7.2 Distillation method
11 -  8 TEST REPORT

Scope

The moisture content of many materials is commonly determined by oven-drying, the change in mass of the material being assumed to be due solely to removal of water. In the case of paper products and pulp this assumption is incorrect. Volatile constituents other than water may be lost in oven-drying and oxidation or decomposition of some constituents is possible at high temperatures.
The quantity of water removed depends on the method of drying adopted. In oven-drying the moisture values obtained are to some extent dependent on the temperature used, the humidity in the oven and also on the time of drying.
When other methods of water removal are used, for instance vacuum desiccation or distillation or extraction with solvents, moisture content values do not always agree with those obtained by an oven-drying method.
The moisture content of paper products and pulps must therefore always be defined in terms of a particular method. This Standard describes the two main procedures.
The method of sampling for determination of moisture content is critical and the relevant Standard, AS 1301.417s-1992 Methods of test for pulp and paper, Method 417s: Sampling paper, board and pulp for testing, fully describes the procedure required.
NOTE 1 - When information is required on variations in moisture content between the centre and edges of sheets or across a reel, a number of test pieces must be cut in a pattern decided by the information required. A scheme for this is described in ISO 287:1985.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	PK-019
Supersedes	AS 1301.457s-1992 DR 06356 CP