Table of Contents

Abstract

Specifies requirements for the design and manufacture of polyethylene storage tanks that are rationally moulded in one-piece seamless construction, for non-buried, vertical installation, and capable of containing water, liquids for food and beverage manufacture and chemical solutions at atmospheric pressure.

Scope

This Standard specifies requirements for the design and manufacture of polyethylene storage tanks that are rotationally moulded in one-piece seamless construction. The tanks are for non-buried, vertical installation and capable of containing water, liquids used in food and beverage manufacture and chemical solutions at atmospheric pressure.
Separation of the roof (lid) from the body of the tank, after moulding, is permitted for transport purposes, provided that-
the structural integrity of the tank is not adversely affected after the roof has been refitted by the manufacturer or its nominated representative in the manner prescribed by the design engineer; and
the prevention of insect and/or vermin ingress is maintained.
Methods for demonstrating compliance with this standard are given in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	PL-046
Supersedes	AS/NZS 4766(Int):2002