Table of Contents

<toc />

Abstract

RECONFIRMATION NOTICE
Technical Committee CE-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 17 December 2015.
The following are represented on Technical Committee CE-009:
Association of Geotechnical Testing Authorities (Qld)
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Geomechanics Society
Australian Stabilisation Industry Association
AUSTROADS
Cement Concrete & Aggregates Australia – Aggregates
Engineering & Construction Laboratories Association
Engineers Australia
National Association of Testing Authorities Australia
The University of Melbourne
The University of Sydney
Victorian Construction Materials Laboratories Association.

Scope

This Standard sets out the method for statistically controlling maximum dry density and optimum moisture content values used for the determination of dry density ratio and moisture ratio. It is applicable to material that contains not more than 20% by mass of material, on a wet basis, retained on the 37.5 mm sieve and where all test and sample sites have been randomly selected from within an area of work (which is defined as a lot).

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016
Pages
ISBN
Committee	CE-009
Supersedes	DR 02556