Abstract

Specifies requirements for eddy current flaw detection of metals and alloys and includes requirements for the preparation of test procedures, calibration standards and calibration procedures.

Scope

This Standard specifies requirements for eddy current flaw detection of metals and alloys and includes requirements for the preparation of test procedures, calibration standards and calibration procedures. It covers the inspection of flat and curved surfaces, and bolt holes.
This Standard does not include criteria for acceptance or rejection.
NOTE: Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	MT-007
Supersedes	DR 05352 AS 4544.1-1999