Table of Contents

Abstract

Specifies the uniform minimum requirements for manufacturers, designers, regulatory authorities, testing laboratories and similar organizations for the safety, performance and use of gas laundry dryers intended for use with natural gas, town gas, tempered liquefied petroleum gas and liquefied petroleum gas.
RECONFIRMATION NOTICE
Technical Committee AG-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 25 September 2015.
The following are represented on Technical Committee AG-001:
Association of Accredited Certification Bodies
Australian Building Codes Board
Consumer Electronics Suppliers Association
Consumers Federation of Australia
Energy Efficiency and Conservation Authority of New Zealand
Energy Networks Association
Gas Appliance Manufacturers Association of Australia
Gas Association of New Zealand
Gas Energy Australia
Gas Technical Regulators Committee
Gas Utilisation Institute, New Zealand
The Australian Gas Association
Worksafe—Energy Safety New Zealand

Scope

These requirements apply to laundry dryers, intended for use with natural gas, town gas, liquefied petroleum gas and tempered liquefied petroleum gas up to a nominal gas consumption of 500 MJ/h.
NOTE: Other statutory and regulatory requirements may be applicable to the product(s) that fall within the scope of this Standard. It is the manufacturer’s, importer’s or distributor’s responsibility (as appropriate) to ensure that products comply with these requirements.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016
Pages
ISBN
Committee	AG-001
Supersedes	DR 04278 CP