Table of Contents

Abstract

Specifies the requirements for non-draining mass-impregnated paper insulated and lead alloy sheathed cables for working voltages up to and including 19/33 (36) kV.
RECONFIRMATION NOTICE
Technical Committee EL-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 10 October 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 13 December 2016.
The following are represented on Technical Committee EL-003:
Australian Cable Makers' Association
Australian Industry Group
Electrical Compliance Testing Association
Electrical Regulatory Authorities Council
National Electrical and Communications Association
Queensland University of Technology

Scope

This Standard specifies requirements for non-draining mass-impregnated paper insulated and lead alloy sheathed cables for working voltage up to and including 19/33 (36) kV. Provision is made for extruded or lapped non-metallic protective coverings over the lead alloy sheath, with or without galvanized steel wire armour. Some typical constructions are shown in Figure 1.
NOTES:
1 Recommendations for selection and operation are given in Appendix A and those for installation are given in Appendix B.
2 Purchasing guidelines are provided in Appendix C.
The following cables are included in this Standard:
(a) 0.6/1 (1.2) kV four-core.
(b) 3.8/6.6 (7.2) kV single-core and three-core belted construction.
(c) 6.35/11 (12) and 11/11 (12) kV single-core and three-core belted or screened construction.
(d) 12.7/22 (24) kV and 19/33 (36) kV single-core and three-core screened or three-core separately leaded (SL).

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 20/01/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 20/01/2017
Pages
ISBN
Committee	EL-003
Supersedes	DR 02316 AS 1026-1992