Table of Contents

Abstract

Provides requirements, test methods and performance criteria for point-type resettable multisensor fire detectors for use in fire detection systems installed in buildings. Modified adoption of ISO 7240-15:2004.
RECONFIRMATION NOTICE
Technical Committee FP-002 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 16 June 2016.
The following are represented on Technical Committee FP-002:
Association of Hydraulic Services Consultants Australia
Australasian Fire and Emergency Service Authorities Council
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Institute of Building Surveyors
CSIRO
Deafness Forum of Australia
Department of Human Services (VIC)
Engineers Australia
Fire Protection Association Australia
National Electrical and Communications Association
National Fire Industry Association
Property Council of Australia
Society of Fire Safety

Scope

This part of ISO 7240 specifies requirements, test methods and performance criteria for point-type resettable multisensor fire detectors for use in fire detection systems installed in buildings, incorporating in one mechanical enclosure at least one smoke sensor and at least one other sensor which responds to heat, and in
which the signal(s) of the smoke sensor(s) is (are) combined with the signal(s) of the heat sensor(s).
The performance of single components within a multisensor fire detector covered by this standard may not be sufficient for conformity to other standards for the single sensor. Certain types of detectors may contain radioactive materials. The national requirements for radiation
protection differ from country to country and they are not therefore specified in this standard. However, such detectors are expected to conform to the national requirements and be in line with the recommendations of the Nuclear Energy Agency (NEA) of the Organisation for Economic Co-operation and Development (OECD)1) .

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 08/07/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 08/07/2016
Pages
ISBN
Committee	FP-002
Under Revision	DR AS 7240.15:2018
Supersedes	DR 03325 CP
Superseded By	AS 7240.15:2018