Table of Contents

Abstract

Specifies general and safety requirements for miscellaneous electronic circuits used with luminaires for use on a.c. supplies up to 1000 V and d.c. supply up to 250 V. This Standard is reproduced from IEC 61347-2-11 and modified to suit national requirements.
RECONFIRMATION NOTICE
Technical Committee EL-041 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 October 2015.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 4 November 2016.
The following are represented on Technical Committee EL-041:
Australian Industry Group
Consumers Federation of Australia
Department of Resources, Energy and Tourism
ECANZ
Electrical Compliance Testing Association
Electrical Regulatory Authorities Council
Energy Efficiency & Conservation Authority of New Zealand
IES: The Lighting Society
Independent Pricing and Regulatory Tribunal
Institution of Professional Engineers New Zealand
Joint Accreditation System of Australia and New Zealand
Lighting Council Australia
Lighting Council New Zealand
Master Electricians Australia
Ministry of Business, Innovation and Employment (NZ)
NSW Fair Trading

Scope

This part of AS/NZS 61347 specifies general and safety requirements for miscellaneous electronic circuits used with luminaires for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz and/or d.c. supplies up to 250 V. This part does not apply to circuits or devices for which specific IEC standards are published.
NOTE Examples of miscellaneous electronic circuits used with luminaires are
– electronic ballast control circuits;
– switching circuits used in association with daylight and/or presence sensors;
– circuits to assist EMC performance;
– intermittence and similar devices used with lighting chains;
– earth leakage or open-circuit protective devices used with neon transformers.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 16/12/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 16/12/2016
Pages
ISBN
Committee	EL-041
Supersedes	DR 02469 CP