Table of Contents

Abstract

Specifies the method for the calibration of reference blocks to be used for the indirect verification of Vickers hardness testing machines as specified in AS 1817.2. This Standard is identical with and has been reproduced from ISO 6507-2:1997.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
The following are represented on Technical Committee MT-009:
Australasian Institute of Surface Finishing
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers

Scope

This part of ISO 6507 specifies a method for the calibration of reference blocks to be used for the
indirect verification of Vickers hardness testing machines, as specified in ISO 6507-2.
The method is applicable only for indentations with diagonals >= 0,020 mm.
The force values in this part of ISO 6507 were calculated from kilogram force values. They were
introduced before the SI-system was adopted. It was decided to keep the values based on the old
units for this edition, but for the next revision it will be necessary to consider the advantage of
introducing rounded values of test force and the consequence on the hardness scales.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 31/03/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 31/03/2017
Pages
ISBN
Committee	MT-006
Supersedes	DR 02408 CP AS 1817-1991