Table of Contents

Abstract

Specifies particular safety requirements for approval and test purposes. It is to be read in conjunction with AS/NZS 60335.1. This Standard is technically equivalent to and reproduced from IEC 60335-2-67:2002.
RECONFIRMATION NOTICE
Technical Committee EL-002 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 28 April 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 18 May 2016.
The following are represented on Technical Committee EL-002:
Australian Industry Group
Australian Retailers Association
Business New Zealand
Consumer Electronics Suppliers Association
Consumers Federation of Australia
Electrical Regulatory Authorities Council
Engineers Australia
Joint Accreditation System of Australia and New Zealand
New Zealand Electric Fence Energiser Manufacturers Standards WG
NSW Fair Trading
Testing Interests (New Zealand)
Worksafe New Zealand

Scope

This clause of Part 1 is replaced by the following.

This International Standard deals with the safety of milking machines, to be used in stalls and in the open, that are designed for milking farm animals, such as cows, the rated voltage of the milking machine being not more than 250 V for single-phase operation and 480 V for other operations.

NOTE 101 Examples of such machines are:
– bucket milking machines;
– direct-to-can milking machines;
– milking pipeline machines;
– recorder milking machines;
– independent air and milk transport milking machines.

NOTE 102 A detailed description of the types of milking machines covered by this standard is given in ISO 3918 and is indicated in Annex AA.

NOTE 103 The upper limit for the rated voltage of 250 V single-phase may be exceeded in cases where 480 V split-phase motors are required.

NOTE 104 This standard applies to milking sub-assemblies supplied by one manufacturer to form a complete milking machine. It can be used as guidance for the safety of milking machines formed from sub-assemblies supplied by different manufacturers.

NOTE 105 Attention is drawn to the fact that:
– for milking machines intended to be used in vehicles or on board ships, additional requirements may be necessary;
– in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities and similar authorities.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 30/09/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 30/09/2016
Pages
ISBN
Committee	EL-002
Under Revision	DR 07910 CP
Supersedes	DR 02910