Table of Contents

Abstract

Specifies requirements for galvanized cold-drawn mild steel wire of round cross-section used for the armouring of electric and telecommunication cables.
RECONFIRMATION NOTICE
Technical Committee EL-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 10 October 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 13 December 2016.
The following are represented on Technical Committee EL-003:
Australian Cable Makers' Association
Australian Industry Group
Electrical Compliance Testing Association
Electrical Regulatory Authorities Council
National Electrical and Communications Association
Queensland University of Technology

Scope

This Standard specifies requirements for cold-drawn mild steel wire of round cross-section, galvanized (zinc-coated) for the armouring of electric and telecommunication cables.
NOTE: Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 20/01/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 20/01/2017
Pages
ISBN
Committee	EL-003
Supersedes	DR 01102 AS 3863-1991