No products
View larger
AS 3894.1-2002 (R2013)
M00003900
New product
AS 3894.1-2002 (R2013)
Site testing of protective coatings Non-conductive coatings - Continuity testing - High voltage ('brush') method
Standards Australia
In stock
More info
Abstract
Technical Committee CH-003 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been determined
that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 25 September 2013.
The following are represented on Technical Committee CH-003:
Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufacturers' Federation
Australian Pipeline Industry Association
Water Corporation Western Australia
Scope
This Standard provides a practical test method for the on-site determination of the presence of pinholes, holidays, cracks and other discontinuities that penetrate to the substrate, in a non-conductive, protective coating of at least 150 mm thickness (see Note) on a conductive substrate, using the high voltage or ‘brush’ method.
NOTE: Where coatings are less than 150 mm thick, an alternative method such as the low voltage wet sponge method should be used.
This Standard is applicable to site testing of coated metal items of equipment or structures which may be subjected to long-term burial or immersion, such as structural steel, pipelines, storage vessels, bridges and mobile/transportable containers. The method is confined to testing instruments that can provide a minimum voltage of 500 V. The Standard is not intended to apply to coating types incorporating components that conduct an electric current, such as zinc dust and aluminium flakes.
The voltages recommended in this Standard are intended to be applied under conditions of normal atmospheric pressure and temperature.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmation Notice 12/11/2013 |
| Committee | CH-003 |
| Supersedes |
|