Abstract

Applies to the measurement of partial discharges which occur in electrical apparatus, components or systems when tested with alternating voltages up to 400 Hz or with direct voltage. Defines the quantities to be measured and describes test and measuring circuits which may be used. It is intended that the provisions of this Standard should be used in the drafting of specifications relating to partial discharge measurements for specific power apparatus. This Standard is identical to and has been reproduced from IEC 60270:2000.
RECONFIRMATION NOTICE
Technical Committee EL-007 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 18 May 2015.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
The following are represented on Technical Committee EL-007:
Ausgrid
Australian Industry Group
Energy Networks Association
Engineers Australia
The University of New South Wales

Scope

This International Standard is applicable to the measurement of partial discharges which occur in electrical apparatus, components or systems when tested with alternating voltages up to 400 Hz or with direct voltage.
This standard
– defines the terms used;
– defines the quantities to be measured;
– describes test and measuring circuits which may be used;
– defines analogue and digital measuring methods required for common applications;
– specifies methods for calibration and requirements of instruments used for calibration;
– gives guidance on test procedures;
– gives some assistance concerning the discrimination of partial discharges from external interference.
The provisions of this standard should be used in the drafting of specifications relating to partial discharge measurements for specific power apparatus. It deals with electrical measurements of impulsive (short-duration) partial discharges, but reference is also made to non-electrical methods primarily used for partial discharge location (see annex F).
Diagnosis of the behaviour of specific power apparatus can be aided by digital processing of partial discharge data (see annex E) and also by non-electrical methods that are primarily used for partial discharge location (see annex F).
This standard is primarily concerned with electrical measurements of partial discharges made during tests with alternating voltage, but specific problems which arise when tests are made with direct voltage are considered in clause 11.
The terminology, definitions, basic test circuits and procedures often also apply to tests with other frequencies, but special test procedures and measuring system characteristics, which are not considered in this standard, may be required.
Annex A provides normative requirements for performance tests on calibrators.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 18/05/2015. This standard as been reconfirmed in Australia in 2015 and remains current in New Zealand. Reconfirmation Notice 18/05/2015
Pages
ISBN
Committee	EL-007
Supersedes	AS 1018-1985 DR 01020 CP