Table of Contents

1 -  AS/NZS 2908.1:2000 CELLULOSE-CEMENT PRODUCTS - CORRUGATED SHEETS
4 -  PREFACE
5 -  CONTENTS
6 -  1 SCOPE
6 -  2 REFERENCED DOCUMENTS
6 -  3 CLASSIFICATION
6 -  4 COMPOSITION
7 -  5 PHYSICAL REQUIREMENTS
7 -  6 DIMENSIONS AND TOLERANCES
8 -  7 BENDING STRENGTH
8 -  8 WATERTIGHTNESS
8 -  9 RESISTANCE TO HOT WATER SOAKING
8 -  10 MARKING
9 -  APPENDIX A - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS STANDARD
9 -  A1 SCOPE
9 -  A2 STATISTICAL SAMPLING
9 -  A3 PRODUCT CERTIFICATION
9 -  A4 SUPPLIER'S QUALITY SYSTEM
10 -  A5 OTHER MEANS OF ASSESSMENT
11 -  APPENDIX B - REFERENCED DOCUMENTS
12 -  APPENDIX C - DETERMINATION OF THE STRENGTH OF CORRUGATED CELLULOSE-CEMENT SHEETS
12 -  C1 SCOPE
12 -  C2 PRINCIPLE
12 -  C3 APPARATUS
13 -  C4 SAMPLING
13 -  C5 TEST PIECES
14 -  C6 PROCEDURE
14 -  C7 REPORT
15 -  APPENDIX D - DETERMINATION OF THE WATERTIGHTNESS OF CORRUGATED CELLULOSE-CEMENT SHEETS
15 -  D1 SCOPE
15 -  D2 PRINCIPLE
15 -  D3 APPARATUS
16 -  D4 SAMPLING
16 -  D5 TEST PIECE
16 -  D6 PROCEDURE
16 -  D7 REPORT
17 -  APPENDIX E - DETERMINATION OF RESISTANCE TO HOT WATER SOAKING OF CORRUGATED CELLULOSE-CEMENT SHEETS
17 -  E1 SCOPE
17 -  E2 PRINCIPLE
17 -  E3 APPARATUS
17 -  E4 SAMPLING
17 -  E5 TEST PIECES
18 -  E6 PROCEDURE
18 -  E7 REPORT

Abstract

Sets out requirements for corrugated cellulose-cement sheets for use primarily as roofing and wall cladding. It applies to auto-claved sheets in which the cement is partially replaced by ground silica. Appendices provide means for demonstrting compliance with this Standard and methods of test for determination of strength, water-tightness, and resistance to hot water soaking of corrugated cellulose-cement sheets.

Scope

This Standard sets out requirements for corrugated cellulose-cement sheets for use primarily as roofing and cladding. It also applies to autoclaved sheets in which the cement is partially replaced by ground silica.
This Standard covers sheets that are finished with one of the following:
(a) Their natural colour.
(b) Colouring matter added to their composition.
(c) Coloured or uncoloured adherent coatings on their surfaces.
This Standard does not apply to asbestos-fibre-reinforced sheets.
NOTE: Advisory information on alternative methods of determining compliance with this Standard is given in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	BD-040
Supersedes	NZS/AS 2908.2 : 1992 AS 2908.1-1992 NZS/AS 2908.1 : 1992 DR 99115