Table of Contents

1 -  AS 2282.2-1999 METHODS FOR TESTING FLEXIBLE CELLULAR POLYURETHANE - MEASUREMENT OF DIMENSIONS OF TEST SPECIMENS
1 -  PREFACE
1 -  FOREWORD
1 -  METHOD
1 -  1 SCOPE
2 -  2 APPARATUS
2 -  2.1 Gauge (Method A)
2 -  2.2 Vernier callipers (Method B)
2 -  2.3 Rule or tape (Method C)
2 -  2.4 Commercial apparatus (alternative Method A)
2 -  3 PROCEDURE
3 -  4 REPORT
4 -  APPENDIX A - EXAMPLE OF SUITABLE APPARATUS FOR METHOD A
4 -  A1 SCOPE
4 -  A2 APPARATUS

Abstract

Sets out three methods for the measurement of test
specimen dimensions of flexible cellular polyurethane.
The methods are as follows:
- Method A - the reference method, which is also
particularly applicable to dimensions
less than 30 mm, utilizes a gauge with
a circular foot;
- Method B - for dimensions over 30 mm, utilizes
vernier callipers;
- Method C - for dimensions over 100 mm, utilizes
a rule or tape measure.

Scope

This Standard sets out three methods for the measurement of test specimen dimensions of flexible cellular polyurethane. The methods are as follows:
(a) Method A-the reference method, which is also particularly applicable to dimensions less than 30 mm, utilizes a gauge with a circular foot.
(b) Method B-for dimensions over 30 mm, utilizes vernier callipers.
(c) Method C-for dimensions over 100 mm, utilizes a rule or tape measure.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Cognizance was taken of ISO 1923:1981 in the preparation of this. revision
Pages
ISBN
Committee	PL-036
Supersedes	AS 2282.2-1991 DR 98385