Table of Contents

1 -  AS 1774.25-1998 REFRACTORIES AND REFRACTORY MATERIALS-PHYSICAL TEST METHODS - DETERMINATION OF DENSITY BY THE REES-HUGILL METHOD
1 -  PREFACE
1 -  METHOD
1 -  1 SCOPE
1 -  2 REFERENCED DOCUMENTS
1 -  3 DEFINITIONS
1 -  3.1 Capacity to any graduation line
1 -  3.2 Powder density
2 -  4 PRINCIPLE
2 -  5 SAFETY
2 -  6 APPARATUS AND MATERIAL
2 -  6.1 Displacement flask
2 -  6.2 Grinder
2 -  6.3 Sieve
2 -  6.4 Drying oven
2 -  6.5 Desiccator
2 -  6.6 Balance
2 -  6.7 Thermostatically controlled water bath
2 -  6.8 Displacement liquid
2 -  6.9 Funnel
2 -  6.10 Pipette
2 -  7 SAMPLE
2 -  8 PROCEDURE
3 -  9 CALCULATION
3 -  10 REPORTING OF RESULTS
4 -  APPENDIX A - DESCRIPTION OF REES-HUGILL POWDER DENSITY FLASK
4 -  A1 SCOPE
4 -  A2 RANGE
4 -  A3 MATERIAL
4 -  A4 CONSTRUCTION
4 -  A4.1 General
4 -  A4.2 Lower section
4 -  A4.3 Bulb
4 -  A4.4 Neck
4 -  A4.5 Stopper
4 -  A5 DIMENSIONS
4 -  A6 CAPACITY
5 -  A7 TOLERANCE ON CAPACITY
7 -  A8 GRADUATION LINES
7 -  A9 LENGTH AND NUMBERING OF GRADUATION LINES
7 -  A10 MARKING
9 -  APPENDIX B - CAPACITIES MEASURED ABOVE THE DATUM MARK CORRESPONDING TO NUMBERED GRADUATION LINES

Abstract

Describes a procedure for determining the density of refractory materials of particle size less than 500 µm.

RECONFIRMATION NOTICE
Technical Committee MN-007 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 4 April 2013.
The following are represented on Technical Committee MN-007:

Australian Institute of Mining and Metallurgy
Australian Ceramic Society
Bureau of Steel Manufacturers of Australia
Cement Industry Federation
CSIRO Manufacturing & Materials Technology
Institute of Refractories Engineers
Refractories Manufacturers Association of Australia
The University of New South Wales


To view or download a copy of the reconfirmation notice please go to the reconfirmation link near the top of this page.

Scope

This Standard describes the procedure for determining the density of refractory materials of particle size less than 500 ¦m. The method is applicable to material of density greater than 2000 kg/m3but less than 4860 kg/m3.

NOTE: This method may not give the true density, which is determined by the method given in AS 1774.6.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 16-07-2013
Pages
ISBN
Committee	MN-007
Supersedes	DR 97399 AS 1774.25-1992