Table of Contents

<toc />

Abstract

RECONFIRMATION NOTICE
Technical Committee CE-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 15 February 2013.
The following are represented on Technical Committee CE-009:

Association of Geotechnical Testing Authorities, Qld
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Geomechanics Society
Australian Stabilisation Industry Association
Austroads
Cement Concrete & Aggregates Australia—Aggregates
Engineering & Construction Laboratories Association
Engineers Australia
National Association of Testing Authorities Australia
University of Melbourne
University of Sydney
Victorian Construction Materials Laboratories Association

To view or download a copy of the reconfirmation notice please go to the reconfirmation link near the top of this page.

Scope

This Standard sets out the method for the determination of the assigned water content, by comparison against a set of primary moisture blocks of a standard moisture block, to be used for the calibration of the moisture mode of nuclear surface moisture-density gauges in accordance with AS 1289.5.8.4. The block shall consist of an array of alternate vertical aluminium or magnesium and polyethylene plates. The assignment of water content is made using comparison against a set of primary moisture blocks. Guidance on the number of blocks required for a set of standard moisture blocks is given in AS 1289.5.8.4.

A separate assigned water content for a particular standard moisture block is required for each make of gauge and, in some cases, for different models of the same make. The determination of the assigned water content for a particular standard moisture block shall be completed within one year of commencement, and the value of the assigned water content for a particular gauge make, and model if necessary, cannot be calculated until all
of the predicted water content values have been obtained.

For any gauge, the determination of a predicted water content value for a standard moisture block is usually made during the calibration, but not as part of the calibration, of the gauge.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 08-07-2013
Pages
ISBN
Committee	CE-009
Supersedes	DR 97121