Table of Contents

Abstract

Specifies methods for obtaining a representative sample of aluminium and aluminium alloys and procedures for the preparation of labratory samples required for the determination of their chemical composition by chemical and spectrochemical analysis.
RECONFIRMATION NOTICE
Technical Committee CH-010 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 27 June 2016.
The following are represented on Technical Committee CH-010:
Australian Aluminium Council
Bureau of Steel Manufacturers of Australia
International Copper Association Australia
International Precious Metals Institute
National Association of Testing Authorities Australia

Scope

This Standard sets out methods for obtaining a representative sample of aluminium and aluminium alloys and procedures for the preparation of laboratory samples required for the determination of their chemical composition by both chemical and spectrochemical analysis. The procedures are suitable for use in manufacturing control, material and product acceptance, and research and development.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 22/07/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 22/07/2016
Pages
ISBN
Committee	CH-010
Supersedes	AS 2612-1983 DR 97005