Abstract

Specifies vibration test procedures and limits for certain d.c. and three-phase a.c. machines at nominal speeds from 600 rev/min to 3600 rev/min. This Standard is identical to, and has been reproduced from, IEC 34-14:1996.

Scope

This part of IEC 34 specifies the vibration test procedures and limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover. It is applicable to d.c. and three-phase a.c. machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at nominal speeds from 600 rev/min up to and including 3600 rev/min. For vertical machines and flange-mounted machines, this standard is only applicable to those machines that are measured in a state of free suspension. This standard is not applicable to machines mounted in situ, three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical water power generators, permanent magnet generators, or series-wound d.c. machines.
NOTE - For machines measured in situ refer to ISO 10816-1 (basic document).

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	EL-009
Supersedes	AS 1359.50-1983 DR 96210