Table of Contents

1 -  AS/NZS 1567:1997 - COPPER AND COPPER ALLOYS - WROUGHT RODS, BARS AND SECTIONS
4 -  PREFACE
5 -  CONTENTS
6 -  1 SCOPE
6 -  2 REFERENCED DOCUMENTS
7 -  3 DEFINITIONS
7 -  3.1 Bar
7 -  3.2 Batch
7 -  3.3 Hollow
7 -  3.4 Rod
7 -  3.5 Section
7 -  4 DESIGNATION
7 -  4.1 General
7 -  4.2 Alloy designation
7 -  4.3 Temper designation
7 -  5 TEMPER OF MATERIAL
7 -  6 CHEMICAL COMPOSITION
7 -  6.1 General
7 -  6.2 Chemical analysis
11 -  7 FREEDOM FROM DEFECTS
11 -  8 MECHANICAL PROPERTIES
11 -  8.1 Selection and preparation of test samples
11 -  8.2 Tensile test
11 -  8.3 Hardness test
11 -  8.4 Bend test
11 -  9 DEZINCIFICATION TEST
12 -  10 MERCUROUS NITRATE TEST
12 -  11 ELECTRICAL RESISTIVITY TEST
12 -  12 HYDROGEN EMBRITTLEMENT TEST
12 -  13 RETESTS
13 -  14 MANUFACTURING TOLERANCES
13 -  15 ROUNDING OF TEST RESULT VALUES
13 -  15.1 General
13 -  15.2 Tensile test results
13 -  16 MARKING
21 -  APPENDIX A - PURCHASING GUIDELINES
21 -  A1 GENERAL
21 -  A2 INFORMATION TO BE SUPPLIEDBY THE PURCHASER
21 -  A3 TEST REQUIREMENTS
21 -  A3.1 Frequency of testing
21 -  A3.2 Independent tests
23 -  APPENDIX B - RELATED ALLOY DESIGNATIONS

Abstract

Specifies requirements for wrought copper and copper alloy rods, bars and sections, including hollow sections, having a diameter or width across flats of not less than 1.6 mm, for machining and general purposes other than forging. It contains a table which relates the alloy designations with other common designations.

Scope

This Standard specifies requirements for wrought copper and copper alloy rods, bars and sections, including hollow sections, having a diameter or width across flats of not less than 1.6 mm, for machining and general purposes other than forging.

NOTE: Advice and recommendations on information to be supplied at the time of inquiry and order are contained in the purchasing guidelines set out in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	MT-002
Supersedes	AS 1567-1985 DR 95457