Table of Contents

Abstract

Specifies the dimensional, material and marking requirements for steel bolt assemblies comprising steel bolts of property class 8.8, steel nuts of property class 8 with ISO metric coarse pitch series threads, in diameters from 12 mm to 36 mm, and associated hardened and tempered steel washers intended for use in steel structures.

Scope

This Standard specifies the dimensional, material and marking requirements for steel bolt assemblies comprising steel bolts of property class 8.8, steel nuts of property class 8 with ISO metric coarse pitch series threads, in diameters from 12 mm to 36 mm, and associated hardened and tempered steel washers intended for use in steel structures. This Standard also specifies an additional bolt assembly type of property class 10.9 to EN 14399.3.
The bolt assemblies are intended to be fully tensioned but may also be used in a snug tight condition or where designed to be partially tensioned. This Standard also sets out tests to verify the suitability of high-strength bolt, nut and washer assemblies for tensioning (preloading) for bolted connections in steelwork construction.
This Standard is intended to apply to the manufacture of high-strength steel bolt assemblies.
NOTE: AS/NZS 1252.2 provides requirements for verification testing.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	ME-029
Supersedes	AS/NZS 1252:1996 DR2 AS/NZS 1252.1:2016 CP