Table of Contents

1 -  AS/NZS 4249:1994 ELECTRICAL SAFETY PRACTICES - FILM, VIDEO AND TELEVISION SITES
4 -  PREFACE
4 -  CONTENTS
5 -  1 SCOPE
5 -  2 APPLICATION
5 -  3 REFERENCED DOCUMENTS
6 -  4 DEFINITIONS
6 -  4.1 Competent person
6 -  4.2 Dry hire studio
6 -  4.3 Gaffer
6 -  4.4 HMI lamp
6 -  4.5 Hook-ups
6 -  4.6 Residual current device (RCD)
6 -  4.7 Site
6 -  4.8 Temporary electrical installation
6 -  5 GENERAL SAFETY PROCEDURES
6 -  5.1 Liquids around electrical equipment
6 -  5.2 Notification of electrical hazards
6 -  5.3 Disconnection of power in adverse conditions
6 -  5.4 Clearance between mechanical equipment and overhead electric power lines
6 -  5.5 Hazardous areas
6 -  6 RESIDUAL CURRENT DEVICES
6 -  6.1 Compliance
7 -  6.2 Protection
7 -  6.3 Testing
7 -  6.4 Recording
7 -  7 CABLES, CORDS AND CORD EXTENSION SETS
7 -  7.1 Cables
8 -  7.2 Cords
8 -  7.3 Cord extension sets
8 -  7.4 Limitations on the use of flexible extension cords and cables
8 -  8 PLUGS, PLUG SOCKET ADAPTORS AND PORTABLE OUTLET DEVICES
8 -  8.1 Plugs
8 -  8.2 Plug socket adaptors
8 -  8.3 Portable outlet devices
8 -  9 PORTABLE DISTRIBUTION BOARDS
8 -  9.1 Construction
9 -  9.2 Cable entry
9 -  9.3 Main isolating switch
9 -  10 LIGHTING FIXTURES AND PORTABLE ELECTRICAL EQUIPMENT
9 -  10.1 Disconnection from the power
9 -  10.2 Support and restraint
9 -  10.3 Protection of electrical equipment from water
9 -  10.4 Total immersion in water of lights and fixtures
9 -  10.5 Protection from ultraviolet radiation from HMI lamps
10 -  10.6 Combustible materials near lamps
10 -  11 LASERS
10 -  11.1 Qualified operator
10 -  11.2 Notification and briefing
10 -  11.3
10 -  11.4 General care
10 -  12 HOOK-UPS (TEMPORARY CONNECTIONS)
10 -  12.1 Qualifications
10 -  12.2 Sufficient time available
10 -  12.3 Signs
10 -  12.4 Identification
10 -  13 GENERATING SETS
10 -  13.1 General
10 -  13.2 Electrical connections
10 -  13.3 Protection
10 -  13.4 Alternative supply
11 -  13.5 Testing
11 -  14 EARTHING AND EQUIPOTENTIAL BONDING
11 -  15 EQUIPMENT TESTING AND RECORDING
11 -  15.1 Electrical equipment
12 -  15.2 Hired equipment and appliances
12 -  15.3 Equipment inspections and tests
12 -  15.3.1 Inspection
12 -  15.3.2 Testing
13 -  16 FIRE EXTINGUISHERS
13 -  16.1 Locations
13 -  16.2 Generating sets

Abstract

Specifies the requirements for safe working practices in the use of electrical equipment on film, video and television sites and the in-service testing of the equipment. It does not apply to theatre stages, concert locations or permanent television studios.

Scope

This Standard indicates the minimum safety requirements for temporary electrical installations which supply electricity to appliances and equipment on film, video and television sites and for the in-service testing of portable and transportable equipment used on these installations. This Standard does not apply to electrical installations on theatre stages, concert locations and permanent television studios, except for additional equipment supplied through a temporary distribution system for film and television work.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-039
Supersedes	DR 94018