Abstract

Specifies a method for determining the coefficient of friction of a test surface that has a rough texture, such as unfinished concrete, but may be applied to smooth or polished surfaces. Identical with and reproduced from ISO 7176-13:1989.

RECONFIRMATION NOTICE
Technical Committee ME-067 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been determined
that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 17 March 2014.
The following are represented on Technical Committee ME-067:
Assistive Technology Suppliers Australasia
Association of Consultants in Access Australia
Australian Rehabilitation in Assistive Technology Association
Consumer Federation of Australia
Department of Family and Communities South Australia
Engineers Australia
Independent Living Centres
Medical Aids Subsidy Scheme
Novita Children’s Services
Occupational Therapy Australia
Physical Disabilities Australia
Queensland Health
Royal Perth Hospital
TAD Australia
The Commercial Vehicle Industry Association of Australia
Therapeutic Goods Administration

Scope

This part of ISO 7176 specifies a test method for determining the coefficient of friction of a test surface that has a rough texture, such as unfinished concrete. In the event that the test method is used for smooth or polished surfaces, care should be exercised that the coefficient of friction is measured as being constant over the whole area of the test surface.

Several test procedures for wheelchairs, e.g. those specified in ISO 7176-1, ISO 7176-2, ISO 7176-3, ISO 7176-6 and ISO 7176-10, require that the coefficient of friction of the test surface be within specified limits.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 23/05/2014. This standard has been reconfirmed in Australia in 2014 and remains current in New Zealand. Reconfirmation Notice 23/05/2014
Pages
ISBN
Committee	ME-067