Table of Contents

Abstract

Specifies performance and general requirements for fittings designed specifically for use with the insulated aerial cables, manufactured to AS 3560, Electric cables - Aerial bundled - Voltages up to and including 0.6/1 kV.
RECONFIRMATION NOTICE
Technical Committee EL-010 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 18 November 2015.
The following are represented on Technical Committee EL-010:
Australian Industry Group
Electricity Engineers Association (New Zealand)
Energy Networks Association

Scope

This Standard sets out performance and general requirements for mechanical fittings and dedicated pole fittings to support low voltage aerial bundled cables manufactured in accordance with AS 3560.

This Standard allows specified components to fail under external mechanical overloads. The design philosophy for this controlled failure mechanism is defined in Appendix A.

NOTE: Appendix B contains the information which should be supplied by the purchaser at the time of enquiry and order.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016
Pages
ISBN
Committee	EL-010
Supersedes	DR 89068