Abstract

Sets out methods for manual ultrasonic testing of carbon and low alloy steel forgings at three recording levels by the use of equivalent reflector sizes. Appendices provide information on probe selection, reflectivity diagrams, testing of curved surfaces, selection of beam angle and classification of discontinuities.

Scope

This Standard sets out methods for manual ultrasonic testing of carbon and low alloy steel forgings, at three recording levels, by the use of equivalent reflector sizes.
NOTE: Appendix A sets out information that should be supplied to the testing personnel before the commencement of the test.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	MT-007
Under Revision	DR 07268
Supersedes	DR 86155