Table of Contents

Abstract

Sets out methods for determining the amount of twist in yarns in terms of turns per unit length in a given direction. Procedures are given for determining the twist in singles, plied (folded) and cabled yarn.
RECONFIRMATION NOTICE
Technical Committee TX-020 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 6 July 2016.
The following are represented on Technical Committee TX-020:
Ag Research
Australian Wool Processors Council
AWTA Textile Testing
Council of Textile and Fashion Industries of Australia
Drycleaning Institute of Australia
National Association of Testing Authorities Australia
RMIT University
The Textile Institute

Scope

This Standard specifies methods for the measurement of case depths of up to 3 mm produced by carburizing, nitriding, carbo-nitriding, or cyaniding heat treatment processes, in steel products.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 05/08/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand." Reconfirmation Notice 05/08/2016
Pages
ISBN
Committee	TX-020
Supersedes	AS L48-1969 DR 85378