Abstract

Specifies requirements for the manufacture, grading, finishing and branding of plywood used specifically in formwork, with a maximum length of 3100 mm and width of 1500 mm, intended to meet off-form surface finish requirements of Classes 2, 3, 4 and 5 as specified in AS 3610.1.

Scope

This Standard specifies requirements for the manufacture, grading, finishing and branding of plywood used specifically in formwork, with a maximum length of 3100 mm and width of 1500 mm, intended to meet off-form surface finish requirements of Classes 2, 3, 4 and 5 as specified in AS 3610.1.
This Standard does not include specifications for formwork plywood intended to meet off-form surface finish Class 1.
Specifications for stress and surface grades, overlays, veneer qualities, bond quality, standard lay-up construction, dimensional tolerances, joints, moisture content and characteristic strength and stiffness values for the nominated F-grades are provided.
The following alternative methods for the determination of stress grades for formwork plywood are specified:
(a) Mechanical F-grading of the finished sheet of formwork plywood.
(b) In-grade testing of finished formwork plywood panels.
Three outer veneer grades, based on the veneer quality of the face and back veneers; F, C and D are prescribed, and four surface quality grades Classes 2, 3, 4 and 5 are described.
Two bond types, A and B, are specified.
Formwork plywood is usually a multiple-use product subject to on-site handling and use, environmental exposure, storage, design and number of re-uses, etc. The physical and structural characteristics of formwork plywood products, as branded and specified in this Standard, are appropriate for the products as manufactured. Inspection of the product is required at all stages including but not limited to, before and after each use, to ensure ongoing required performance across all characteristics.
NOTE: Structural adjustment factors for multiple uses are specified in AS 3610.1.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	TM-011
Supersedes	DR AS 6669:2015 AS 6669-2007