Scope

This part of IEC 60079 specifies the requirements, testing and marking of equipment emitting optical radiation intended for use in explosive atmospheres. It also covers equipment located outside the explosive atmosphere or protected by a Type of Protection listed in IEC 60079-0, but which generates optical radiation that is intended to enter an explosive atmosphere. It covers Groups I, II and III, and EPLs Ga, Gb, Gc, Da, Db, Dc, Ma and Mb.
This standard contains requirements for optical radiation in the wavelength range from
380 nm to 10 µm. It covers the following ignition mechanisms:
-Optical radiation is absorbed by surfaces or particles, causing them to heat up, and under
certain circumstances this may allow them to attain a temperature which will ignite a
surrounding explosive atmosphere.
-In rare special cases, direct laser induced breakdown of the gas at the focus of a strong
beam, producing plasma and a shock wave both eventually acting as ignition source.
These processes can be supported by a solid material close to the breakdown point.
NOTE 1 See a) and d) of the introduction.
This standard does not cover ignition by ultraviolet radiation and by absorption of the radiation in the explosive mixture itself. Explosive absorbers or absorbers that contain their own oxidizer as well as catalytic absorbers are also outside the scope of this standard.
This standard specifies requirements for equipment intended for use under atmospheric conditions.
This standard supplements and modifies the general requirements of IEC 60079-0. Where a
requirement of this standard conflicts with a requirement of IEC 60079-0, the requirement of
this standard takes precedence.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-014
Supersedes	DR AS/NZS 60079.28:2015 AS/NZS 60079.28:2007