Abstract

This Standard sets out the requirements for determining the float and sink characteristics of higher rank coal (refer to AS 2096) and sets out procedures for deriving test samples and methods for presenting the washability data.

Scope

This Standard sets out the requirements for determining the float and sink characteristics of higher rank coal (refer to AS 2096) and sets out procedures for deriving test samples and methods for presenting the washability data.
NOTE This Standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Float and sink testing is the division of a sample into relative density fractions within defined ranges. The proportions of the fractions are expressed as mass percentages of the total sample, commonly with an indication of the ash percentage (and other characteristics, if required) of each fraction.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	MN-001
Supersedes	DR AS 4156.1.1:2018 AS 4156.1-1994 (R2013)