Table of Contents

Foreword
Notice
Committee Roster
Board Roaster
1 Introduction
2 Definitions and Description of Terms
3 Guidance for Comparison of Test Results
4 Flow Measurement by the Enthalpy-Drop Method
5 Sample Calculation for the Reynolds Number Extrapolation
   of a Calibrated ASME Test Flow Section
6 Sample Calculations for a Test of a Complete Expansion
   Condensing Turbine Using U.S. Customary Units
6A Sample Calculations for a Test of a Complete Expansion
   Condensing Turbine Using SI Units
7 Sample Calculations for a Test of a Non-Reheat Regenerative
   Cycle Turbine
8 Sample Calculations for a Test of a Reheat-Regenerative
   Cycle Turbine
8A Sample Calculations for a Test of a Reheat-Regenerative
   Cycle Using the Alternative Procedure With Final Feedwater
   Flow Measurement
9 Sample Calculations for a Steam Turbine Operating in a
   Nuclear Cycle
10 Sample Calculations for a Test of an Automatic Extraction
   Non-condensing Turbine
11 Sample Calculations for a Test of an Automatic Extraction
   Condensing Turbine
12 Sample Calculations for a Test of a Variable Speed Mechanical
   Drive Turbine
13 Sample Calculations for a Test of a Refurbished LP Turbine
   Using U.S. Customary Units

Abstract

Enhances the calculation and correction of turbine test results by furnishing numerical examples of the procedures outlined in PTC 6, the Performance Test Code on Steam Turbines.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	American Society of Mechanical Engineers
ProductNote	Reconfirmed 2000
Pages
ISBN