Table of Contents

Foreword<br>Committee Roster <br>Correspondence with the B89 Committee<br>0 Introduction<br>1 Scope<br>2 Normative References<br>3 Definitions<br>4 Nomenclature of Faces<br>5 Basis of Measurement, Traceability, and Reference Condition<br>6 General Dimensions, Material Properties, and Marking<br>7 Metrological Requirements<br>8 Calibration of Gage Blocks<br>Nonmandatory Appendices<br>A - Grade 00<br>B - Differences Between Former GGG-G-15C and This Standard<br>C - Testing Methods<br>D - Possible Sources of Measurement Uncertainty<br>E - Thin Gage Blocks (Less Than 1.0 mm or 0.040 in.)<br>F - Use and Care of Gage Blocks<br>G - Gage Block Sizes and Sets<br>H - Gage Block Accessories<br>I - Gravity and Atmospheric Effects on Gage Blocks

Abstract

Describes the most important design and metrological characteristics of gage blocks with a rectangular or square cross-section and a nominal length l[n] ranging from 0.5 mm to 1000 mm for metric sizes and 0.010 in. to 40 in. for inch sizes.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	American Society of Mechanical Engineers
ProductNote	Reconfirmed 2007
Pages
ISBN