Table of Contents

Foreword<br>Introduction<br>1 Scope<br>2 Normative references<br>3 Terms and definitions<br>4 Symbols<br>5 Preliminary tests<br>6 Tractor and test preparation<br>7 Test apparatus and equipment<br>8 Test procedures<br>9 Seat index point<br>10 Clearance zone<br>11 Tolerances<br>12 Acceptance conditions<br>13 Extension to other models<br>14 Labelling<br>15 Test report<br>Annex A (normative) - Requirements for providing resistance <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;to brittle fracture of front-mounted ROPS at a <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;reduced operation temperature<br>Annex B (normative) - Test report for front-mounted ROPS<br>Annex C (normative) - Non-continuous rolling test procedure <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;- Calculation method<br>Bibliography

Abstract

Describes procedures for both the static and dynamic testing of roll-over protective structures (ROPS) front-mounted on narrow-track wheeled agricultural and forestry tractors. Also defines the clearance zone and acceptance conditions for rigid or tiltable, front, two-post ROPS, including any associated rear fixtures, and is applicable to tractors so equipped having the following characteristics.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Canadian Standards Association
ProductNote	Reconfirmed EN
Pages
ISBN