Table of Contents

Part I: Construction
1.1 Scope
1.2 General Construction and Assembly
1.3 Housing
1.4 Pressure Relief Valves
1.5 Filters
1.6 Valves
1.7 Venting
1.8 Piping and Fittings
1.9 Hoses and Nozzles
1.10 Pressure Indicating Devices
1.11 Overfill Protection
1.12 Automatic Temperature Compensation
1.13 Electrical Equipment and Wiring
1.14 Emergency Shutdown Systems
1.15 Installation, Service And Operating Instructions
1.16 Marking
Part II: Performance
2.1 General
2.2 Leakage
2.3 Impact
2.4 Dispenser Shut-down
2.5 Hose Rupture
2.6 Hose Breakaway
2.7 Purging System Failure
2.8 Vehicle-Dispenser Interface
2.9 Dispenser Ground Continuity
2.10 Dielectric Voltage-Withstand Test
2.11 Rain
2.12 Protection Parameters
2.13 Marking Material Adhesion And Legibility
Part III: Manufacturing And Production Tests
Part IV: Definitions
EXHIBIT A - List Of Reference Standards
EXHIBIT B - Reference List Of All CSA America HGV
            Series Of Documents1

Abstract

Pertains to: a. The mechanical and electrical features of newly manufactured systems that dispense compressed hydrogen gas for vehicles (HGV) where such systems are intended primarily to dispense the fuel directly into the fuel storage container of the vehicle; b. HGV dispensers that integrate in a single unit multiple dispensing functions (e.g., fuel metering, registering, control and management devices, vehicle fuel cylinder overfill and over pressure protection with listed hoses with nozzles); and c. The following service pressures are applicable, 25MPa, 35MPa, 50MPa, 70MPa: Each dispenser may have the capability of independently fueling more than one vehicle simultaneously.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Canadian Standards Association
Pages
ISBN