Table of Contents

Introduction
1. Scope
2. Definitions and reference publications
   2.1 Definitions
   2.2 Reference publications
3. Equipment related requirements based directly
   on canadian electrical code, part 1 rules
   3.1 Voltage
   3.2 Motors and control
   3.3 Space heating equipment
   3.4 Air-conditioning equipment
   3.5 Water heaters
   3.6 Heating and cooking equipment/appliances
   3.7 Class 2 circuits operating at more than
        42.4V peak or DC
4. Equipment related requirements based indirectly
   on canadian electrical code part I rules
   (compatibility) or general requirements of
   canadian electrical code, part II
   4.1 Supply system compatibility
   4.2 Cord connected equipment
   4.3 Permanently connected equipment
   4.4 Terminals
   4.5 Receptacles for general purpose mains
        output
   4.6 Fuses and fuseholders
   4.7 Safety controls
   4.8 Wiring outside enclosure
   4.9 Equipment for hazardous locations
   4.10 Submersible equipment
   4.11 Equipment protected by a class a ground
        fault circuit interrupter
5. Equipment related requirements based on
   canadian codes other than the canadian electrical
   code, parts I and II
Diagram

Abstract

Applies to electrical equipment design to meet requirements of International Electrotechnical Commission (IEC) Standards and intended to be installed and used in accordance with the rules of the Canadian Electrical Code.

Scope

This Guide for Electrical Equipment for Installation and Use in Canada applies to electrical equipment designed to meet requirements of International Electrotechnical Commission (IEC) Standards and intended to be installed and used in accordance with the Rules of the Canadian Electrical Code, Part I.1.2 This Guide is intended to provide guidance for the uniform application of requirements derived from the Canadian Electrical Code, Part / that are related to the design of electrical products.Clause 3 applies to equipment related requirements which are based directly on Rules of the Canadian Electrical Code, Part Clause 4 applies to equipment related requirements based indirectly on Canadian Electrical Code, Part I, Rules (compatibility) or general requirements of the Canadian Electrical Code,Part II that are relevant to Part I.Clause 5 applies to equipment related requirements based on Canadian Codes other than the Canadian Electrical Code, Parts / and I

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Canadian Standards Association
Pages
ISBN