Scope

This part of ISO 12614 specifies tests and requirements for the rigid fuel line in copper, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This part of ISO 12614 is not applicable to the following: a) fuel containers; b) stationary gas engines; c) container mounting hardware; d) electronic fuel management; e) refueling receptacles. NOTE 1 It is recognized that miscellaneous components not specifically covered herein can be examined to meet the criteria of this part of ISO 12614 and tested according to the appropriate functional tests. NOTE 2 All references to pressure in this part of ISO 12614 are to be considered gauge pressures unless otherwise specified. NOTE 3 This part of ISO 12614 is based upon a working pressure for natural gas as a fuel of 1,6 MPa (16 bar). (1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.) Other working pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, a 2 MPa (20 bar) working pressure system will require pressures to be multiplied by 1,25

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Canadian Standards Association
Pages
ISBN
Committee	ISO/TC 22