Table of Contents

PART 1 - SCOPE<br>&nbsp;1.1 Applicability<br>&nbsp;1.2 Safe and Satisfactory Operation<br>&nbsp;1.3 Installation <br>PART 2 - VISUAL INSPECTION<br>&nbsp;2.1 Air for Combustion and Ventilation<br>&nbsp;2.2 Combustion Chamber Liner <br>&nbsp;2.3 Vent Connector <br>&nbsp;2.4 Chimney <br>&nbsp;2.5 Accessories<br>&nbsp;2.6 Vent Damper Devices<br>&nbsp;2.7 Electrical Supply Considerations<br>&nbsp;2.8 Plate <br>PART 3 - SELECTION AND SIZING OF CONVERSION BURNER<br>&nbsp;3.1 General <br>&nbsp;3.2 Typical Conversion Burner Types <br>&nbsp;3.3 Appliance Design Features<br>&nbsp;3.4 Heat Loss Determination <br>&nbsp;3.5 Input Rate Determination<br>&nbsp;3.6 Preliminary Burner Selection<br>&nbsp;3.7 Final Burner Selection<br>PART 4 - PREPARATION OF EXISTING HEATING PLANT<br>&nbsp;4.1 Cleaning <br>&nbsp;4.2 Reconditioning<br>&nbsp;4.3 Combustion Chamber Linings<br>&nbsp;4.4 Water Heating Coils <br>&nbsp;4.5 Use of Asbestos<br>PART 5 - PREPARATION OF EXISTING HEATING SYSTEM<br>&nbsp;5.1 Chimneys<br>&nbsp;5.2 Vent Connector and Chimney Sizing<br>&nbsp;5.3 Pitch<br>&nbsp;5.4 Revertible Flues<br>&nbsp;5.5 Support and Clearance<br>&nbsp;5.6 Draft Hoods and Barometric Draft Regulators<br>&nbsp;5.7 Vent Connection<br>PART 6 - GAS PIPING<br>&nbsp;6.1 General<br>&nbsp;6.2 Installation of piping<br>&nbsp;6.3 Inspection and Testing of Piping <br>PART 7 - INSTALLATION OF BURNER<br>&nbsp;7.1 Field Installation of Electrical Wiring<br>&nbsp;7.2 System Safety and Limiting Devices <br>&nbsp;7.3 Inspection of Burner and Controls <br>&nbsp;7.4 Placement of Burner <br>PART 8 - START-UP AND ADJUSTMENT<br>&nbsp;8.1 General<br>&nbsp;8.2 Recommended Instruments <br>&nbsp;8.3 Leak Test (Low Pressure)<br>&nbsp;8.4 Input Adjustment and Orifice Pressure<br>&nbsp;8.5 Adjustment of Draft <br>&nbsp;8.6 Preliminary Adjustment of Combustion Air<br>&nbsp;8.7 Final Adjustment<br>&nbsp;8.8 Final Checking <br>PART 9 - COMPLETING THE INSTALLATION<br>&nbsp;9.1 Oil Storage System<br>&nbsp;9.2 Solid Fuel System <br>&nbsp;9.3 Cleaning <br>&nbsp;9.4 Instructions to Customers<br>&nbsp;9.5 Placement of Manufacturer'sÆ instructions<br>&nbsp;9.6 Installation Adjustment Data <br>&nbsp;9.7 Gas Supplier Notification <br>EXHIBIT LIST OF REFERENCED STANDARDS <br>PART 10 - DEFINITIONS

Abstract

Outlines installation requirements for domestic gas conversion burners which use natural, mixed, manufactured and liquefied petroleum gases and LP gas-air mixtures.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Canadian Standards Association
ProductNote	Reconfirmed EN
Pages
ISBN