Table of Contents

Foreword
1 Scope
2 Normative references
3 Definitions and abbreviations
   3.1 Definitions
   3.2 Abbreviations
4 General
   4.1 Presentation of equipment for testing purposes
   4.2 Description of equipment
   4.3 Host-connected equipment
5 Unwanted emissions outside the band 1 610 to 1 626,5 MHz
   and the band 1 626,5 to 1 628,5 MHz (carrier-on)
   5.1 Justification
   5.2 Purpose
   5.3 Conformance requirements
   5.4 Method of test
   5.5 Test requirements
6 Unwanted emissions within the band 1 610 to 1 626,5 MHz
   and the band 1 626,5 to 1 628,5 MHz (carrier-on)
   6.1 Justification
   6.2 Purpose
   6.3 Conformance requirements
   6.4 Method of test
   6.5 Test requirements to
7 EIRP density within the operational band
   7.1 Justification
   7.2 Purpose
   7.3 Conformance requirements
   7.4 Method of test
   7.5 Test requirements
8 Unwanted emissions in carrier-off state
   8.1 Justification
   8.2 Purpose
   8.3 Conformance requirements
   8.4 Method of test
   8.5 Test requirements
9 MES Control and Monitoring Functions (CMF)
   9.1 Special Test Equipment (STE)
   9.2 Self-monitoring functions
   9.3 Network control authorization and reception
   9.4 Fellow radio stations in a dual-mode or
       multi-mode terminal
10 Equipment identity
   10.1 Justification
   10.2 Purpose
   10.3 Conformance requirements
   10.4 Method of test
   10.5 Test procedure
   10.6 Test requirements
11 Protection of the radio astronomy service operation
   in the band 1 610,6 to 1 613,8 MHz
   11.1 Justification
   11.2 Purpose
   11.3 Conformance requirements
   11.4 Method of test
   11.5 Test procedure
   11.6 Test requirement
Annex A (normative): General test requirements
      A.1 MES test modes
      A.2 Special Test Equipment (STE)
      A.3 Laboratory Test Equipment (LTE)
      A.4 Methods of test for MES RF emissions
      A.5 Interpretation of the measurement results
      A.6 Test report
Annex B (normative): Environmental conditions and host
        connected equipment
      B.1 General
      B.2 Environmental requirements
      B.3 Environmental test conditions
      B.4 Testing of host-connected equipment and
          plug-in modules
Annex C (normative): Procedures for measurement of
        radiated emissions
      C.1 General
      C.2 Measurement procedure for radiated emissions
          (peak)
      C.3 Measurement procedure for radiated emissions
          (average)
Annex D (normative): Procedures for measurement of
        conducted emissions
      D.1 General
      D.2 Measurement procedure for conducted emissions
          (peak)
      D.3 Measurement procedure for conducted emissions
          (average)
Annex E (informative): Explanation of nominated bandwidth
      E.1 Introduction
      E.2 Interpretation of Parameters [Bn, fc, a, b]
      E.3 Choice of nominated bandwidth
      E.4 Maximum value for nominated bandwidth
Annex F (normative): The TBR Requirements Table (TBR-RT)
Annex G (informative): Bibliography
History

Abstract

This TBR specifies those technical requirements under Article 4 of Council Directive 93/97/EEC[1] that apply to Mobile Earth Station (MES) equipment with both transmit and receive capabilities for operation in a satellite - Personal Communications Network (S-PCN). These MESs include handheld, portable and vehicle mounted equipment or may be a component in a multi-mode terminal; they may consist of a number of modules with associated connections and user interface, or may be self contained, single units. If the MES is a component in a multi-mode terminal, this TBR applies only to the MES component of the terminal, unless otherwise stated.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	European Telecommunications Standards Institute
Pages
ISBN
Committee	SES