Table of Contents

Foreword
Introduction
1 Scope
2 References
3 Definitions, symbols and abbreviations
  3.1 Definitions
  3.2 Symbols
  3.3 Abbreviations
4 General requirements
  4.1 Test environment
  4.2 Calibration
5 Calculation of measurement uncertainty
  5.1 General
  5.2 Specific to radio equipment
  5.3 Noise behaviour in receivers
  5.4 Uncertainty in measuring third order intermodulation
      rejection
  5.5 Uncertainty in measuring continuous bit streams
  5.6 Uncertainty in measuring messages
  5.7 Detailed example of the calculation of measurement
      uncertainty (Carrier power)
6 Transmitter measurement examples
  6.1 Frequency error
  6.2 Carrier power
  6.3 Frequency deviation
  6.4 Adjacent channel power
  6.5 Conducted spurious emissions
  6.6 Cabinet radiation
  6.7 Intermodulation attenuation
  6.8 Transmitter attack/release time
  6.9 Transient behaviour of the transmitter
7 Receiver measurement examples
  7.1 Maximum usable sensitivity
  7.2 Amplitude characteristic
  7.3 Two signal measurements
  7.4 Intermodulation response
  7.5 Conducted spurious emissions
  7.6 Cabinet radiation
8 Duplex operation measurements
  8.1 Receiver desensitisation
  8.2 Receiver spurious response rejection
Annex A: Maximum accumulated measurement uncertainty
Annex B: Interpretation of the measurement results
Annex C: Influence quantity dependency functions
Annex D: Bibliography
History

Abstract

Gives a method to be applied to all the applicable standards and ETRs, and supports ETSI Technical Report (ETR) 027 (1) ("Methods of measurement for mobile radio equipment").

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	European Telecommunications Standards Institute
Pages
ISBN
Committee	RES 2