M00043649
New product
INTEGRATED SERVICES DIGITAL NETWORK (ISDN); SUPPORT OF PACKET-MODE TERMINAL EQUIPMENT BY AN ISDN
European Telecommunications Standards Institute
In stock
Warning: Last items in stock!
Availability date: 11/06/2021
Foreword
Introduction
Normative references
1 Scope
2 General service aspects
3 Reference configurations
3.1 Configuration when accessing PSPDN services
(Case A)
3.2 Configuration for the ISDN virtual circuit
service (Case B)
4 Service aspects
4.1 Access to PSPDN services (Case A)
4.2 Access to the ISDN virtual circuit service
(Case B)
4.3 Compatibility checking
5 Addressing and routing aspects
5.1 Terminal interface selection
5.2 Access to PSPDN services (Case A)
5.3 Access to the ISDN virtual circuit service
(Case B)
6 Interworking with dedicated networks
6.1 Circuit-mode access to PSPDN services (Case A)
6.2 Access to PSPDNs via virtual circuit service
(Case B)
7 Packet communications at the S/T reference point
7.1 Outgoing access
7.2 Incoming access
7.3 Virtual call establishment and release
7.4 Call clearing
7.5 Access collision
8 Terminal adaptor functionalities
8.1 General
8.2 Physical interfaces
8.3 Access through the B-channel
8.4 Access through the D-Channel
8.5 Access through the B- and D-channel
8.6 Test loops
Appendix I (informative): B-channel TA acting on layer
2 and 3 of CCITT
Recommendation X.25
I.1 Introduction
I.2 Call control
Appendix II (informative): Interconnection of
packet-mode TE2s which use
the circuit-mode bearer
service of the ISDN
Appendix III (informative): Example message flow
diagrams and example
conditions for cause mapping
Appendix IV (informative): D-channel TAs requiring full
protocol termination in the TA
IV.1 Introduction
IV.2 Call control
Annex A (informative): States applicable to packet mode
access connection (case B
services)
A.1 Access connection states at the user side
of the interface
A.2 Access connection states at the network
side of the interface
Annex B (normative): Messages for control of packet-mode
access connections
B.1 Alerting
B.2 Call proceeding
B.3 Connect
B.4 Connect acknowledge
B.5 Disconnect
B.6 Progress
B.7 Release
B.8 Release complete
B.9 Setup
B.10 Status
B.11 Status enquiry
Annex C (normative): Information elements for the
control of packet-mode access
connections
C.1 Protocol discriminator
C.2 Call reference
C.3 Message type
C.4 Other information elements
C.5 Redirecting number
Annex D (informative): Example of ISDN CCITT
Recommendation X.25 packet-mode
bearer service access on the
D-channel through a NT2 with
frame handling Functions
History
Defines user-network signalling requirements to support: the ISDN packet mode bearer services (both B and D Channels); the application of the ISDN circuit mode 8 kHz structured 64 kbit/s unrestricted bearer service category for access to a Packet Switched Public Data Network (PSPDN); for the pan-European Integrated Services Digital Network (ISDN) as provided by European public telecommunication operators at the T reference point or coincident S and T reference point, by using the Digital Subscriber Signalling System number one (DSS1). Stage three identifies the switching functions and protocols needed to support telecommunication services. Applies to user and network equipment supporting case a) or case b), to be attached at either side of a T reference point or coincident S & T reference points.
Published | |
Document Type | Standard |
Status | Current |
Publisher | European Telecommunications Standards Institute |
Pages | |
ISBN | |
Committee | SPS 5 |