M00043707
New product
ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); ENHANCED RADIO MESSAGE SYSTEM (ERMES); RECEIVER REQUIREMENTS
European Telecommunications Standards Institute
In stock
Warning: Last items in stock!
Availability date: 11/06/2021
Foreword
1 Scope
2 Normative references
3 Definitions, abbreviations and symbols
3.1 Introduction
3.2 Vocabulary
3.3 Abbreviations and acronyms
3.4 Symbols
4 General
4.1 Introduction
4.2 Choice of model for approval testing
4.3 Description of equipment
4.4 Mechanical and electrical design
4.5 Categories and classes of receivers
4.6 Requirements and justifications
4.7 Interpretation of measurement results
5 General test requirements
5.1 Test philosophy
5.2 Receiver to be submitted for conformance testing
5.3 Normal test conditions
5.4 Extreme test conditions
5.5 Test fixture
5.6 Test paging signal
5.7 Declared category
6 TBR requirements table
7 Tests for radio parameter conformance
7.1 Conformance requirements
7.2 Method of measurement
8 Tests for radio interface conformance
8.1 Last message in batch
8.2 Message continued in next batch
8.3 Message in last available batch
8.4 Tenure of message
8.5 Two messages in same batch
8.6 Message continued in the next sub-sequence
8.7 Message reception on all ERMES channels
8.8 Recognition of zone code
8.9 Two messages in the same batch
8.10 Message reception in overlap regions (BAI = 1)
8.11 Message reception in overlap regions (BAI = 0)
8.12 Messages
8.13 Termination of numeric messages due to reception
errors
8.14 Termination of alphanumeric messages
8.15 Group call
8.16 Tenure of group message
8.17 Recognition of FSI
8.18 Multioperator environment
Annex A (normative): Measurement procedures
A.1 Average measured usable sensitivity expressed
as field strength under normal conditions
A.2 Radiated spurious components
A.3 Co-channel rejection
A.4 Adjacent channel selectivity
A.5 Spurious response immunity
A.6 Intermodulation immunity
A.7 Blocking immunity
A.8 Combined multi-path and quasi-synchronous
transmissions
Annex B (normative): Ancillary test data
B.1 Simulated man
B.2 Definition of unwanted test signal
B.3 Definition of reference figure
B.4 Sensitivity measurement test sites
B.5 Definition of test sites suitable for spurious
emissions measurements
B.6 Description of test fixtures
B.7 Measurement uncertainty
B.8 Maximum degradation in required sensitivity
B.9 Differential factors
B.10 Calculations of spurious responses frequencies
Annex C (normative): Character sets in the ERMES system
C.1 Characters for numeric paging
C.2 Characters for alphanumeric paging
History
Revision of TBR 007 Ed 1 (11/94) to add further essential requirements resulting from field tests and operation e.g.; multi- network operation, - locking/non-locking receivers, - management of paging area, - OPID, etc.
Published | |
Document Type | Standard |
Status | Current |
Publisher | European Telecommunications Standards Institute |
Pages | |
ISBN | |
Committee | ERM RP04 |
Supersedes |
|