Table of Contents

Foreword
1 Scope
2 Normative references
3 Definitions, symbols and abbreviations
  3.1 DECT definitions
  3.2 DECT abbreviations
  3.3 ISO 9646 definitions
  3.4 ISO 9646 abbreviations
  3.5 Other abbreviations
4 Test suite structure
  4.1 How to use the ATS
  4.2 For the PT
  4.3 For the FT
  4.4 PRotocol (PR) test groups
  4.5 Real Effects (RE) tests
  4.6 Test group naming
  4.7 Test case naming
5 PT test purposes
  5.1 Introduction
  5.2 PAPP/PR/Capability Tests (CA)
  5.3 PAPP/PR/Valid Behaviour (BV)
  5.4 PAPP/PR/Invalid Behaviour (BI)
  5.5 PAPP/PR/InOpportune Behaviour (BO)
  5.6 PAPP/Real Effects (RE)
6 FT test purposes
  6.1 Introduction
  6.2 PAPF/PR/Capability Tests (CA)
  6.3 PAPF/PR/Valid Behaviour (BV)
  6.4 PAPF/PR/Invalid Behaviour (BI)
  6.5 PAPF/PR/InOpportune Behaviour (BO)
  6.6 PAPF/Real Effects (RE)
7 Test method
8 Test case execution sequence
  8.1 PT ATS
  8.2 FT ATS (for IUT supporting incoming calls)
  8.3 FT ATS (for IUT NOT supporting incoming calls)
9 PAP security requirements
  9.1 Manufacturers declarations for full access
      protection (type A)
  9.2 Manufacturers declarations for authorised access
      protection (type B)
10 PAP physical layer requirements
  10.1 Normal Transmitted Power (NTP)
  10.2 RFP radio receiver sensitivity
11 DAM testing
Annex A (informative): Test system assumptions
  A.1 General assumptions
  A.2 Lower tester assumptions
  A.3 Upper tester assumptions when testing the PT
  A.4 Upper tester assumptions when testing the FT
  A.5 Network layer assumptions
  A.6 MAC layer assumptions
Annex B (normative): Additional PAP requirements for
                     inter-operability
  B.1 IWU
  B.2 Network layer requirements
  B.3 DLC layer requirements
  B.4 MAC layer requirements
  B.5 Physical layer requirements
  B.6 Broadcast attributes interpretation
Annex C (normative): Real effects test procedures
  C.1 Introduction
  C.2 Test condition
  C.3 PAPP/RE
  C.4 PAPF/RE
Annex D (informative): Test case example
  D.1 CC example
Annex E (informative): Bibliography
History

Abstract

Based upon the Public Access Profile (ETS 200 175 9) and ISO 9646, to develop a PT and FT abstract test suite. This shall include both the tests required for TBR 11 and those required for voluntary conformance testing, in total, all of the PAP features. The tests shall use the Remote Single Layer Embedded test method.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	European Telecommunications Standards Institute
Pages
ISBN
Committee	RES 3
Supersedes	PRETS 300 323-1 : NOV 93 PRI-ETS 300 323-1 : FEB 93