Table of Contents

Intellectual property rights
Foreword
Introduction
1. Scope
2. References
3. Definitions, symbols and abbreviations
    3.1 Definitions
    3.2 Symbols
    3.3 Abbreviations
4. General
    4.1 Presentation of equipment for testing purposes
    4.2 Mechanical and electrical design
    4.3 Declarations by the applicant
    4.4 Auxiliary test equipment
    4.5 Interpretation of the measurement results
5. Test conditions, power sources and ambient temperatures
    5.1 Normal and extreme test conditions
    5.2 External test power source
    5.3 Normal test conditions
    5.4 Extreme test conditions
6. General conditions
    6.1 Test signals and test modulation
    6.2 Modes of operation of the transmitter
    6.3 Encoder for receiver measurements
    6.4 Facilities for access
    6.5 Test sites and general arrangements for radiated
        measurements
    6.6 Artificial antenna
    6.7 Test fixture
7. Methods of measurement and limits for Road Side Unit
    (RSU) transmitter parameters
    7.1 Equivalent isotropically radiated power (eirp)
    7.2 Frequency error
    7.3 Transmitter spectrum mask
    7.4 Modulation depth
    7.5 Eye pattern
    7.6 Spurious emissions
8. Methods of measurement and limits for RSU receiver
    parameters
    8.1 Maximum useable sensitivity
    8.2 Error behaviour at high wanted input signals
    8.3 Degradation measurements
    8.4 Spurious emissions
9. Method of measurements and limits for On Board Units
    (OBUs)
    9.1 OBU sensitivity
    9.2 On board unit access
    9.3 Transponder conversion gain
    9.4 OBU maximum radiated subcarrier
    9.5 OBU frequency error
    9.6 OBU spurious radiation
10. Measurement uncertainty
Annex A (normative): Radiated measurements
        A.1 Test sites and general arrangements for
            measurements involving the use of radiated fields
        A.2 Guidance on the use of radiation test sites
        A.3 Further optional alternative indoor test site
            using a fully anechoic RF chamber
Annex B (normative): General description of measurement
        methods
        B.1 Conducted measurements
        B.2 Radiated measurements
Annex C (normative): Receiver methods of measurements using
        messages
        C.1 General
        C.2 Test signals
        C.3 Method of measurement for receiver sensitivity
        C.4 Method of measurements for receiver degradation
History

Abstract

Describes radio parameters which are necessary for the efficient use of the radio spectrum and for the purpose of type approval which includes methods of measurements for verifying the limits stated in the present document.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	European Telecommunications Standards Institute
Pages
ISBN
Committee	ERM RP08