M00044427
New product
DIGITAL ENHANCED CORDLESS TELECOMMUNICATIONS (DECT); TEST SPECIFICATION; PART 1: RADIO
European Telecommunications Standards Institute
In stock
Warning: Last items in stock!
Availability date: 11/06/2021
Intellectual Property Rights
Foreword
Modal verbs terminology
1 Scope
2 References
3 Definitions, symbols and abbreviations
4 General
5 General test requirements
6 Test conditions, power sources and ambient
temperatures
7 Accuracy and stability of RF carriers
8 Accuracy and stability of timing parameters
9 Transmission burst
10 Transmitted power
11 RF carrier modulation
12 Unwanted RF power radiation
13 Radio receiver testing
14 Intersystem synchronization (FP only)
15 EMC
16 Equipment identity testing
17 Efficient use of the radio spectrum
18 WRS testing
19 Requirements for PPs with direct PP to PP
communication mode
20 Distributed communications
21 Higher level modulation options
Annex A (normative) - Procedures for test fixture
calibration and for measurement of radiated
spurious emissions
Annex B (normative) - Procedure for measurement of
conducted spurious emissions
Annex C (normative) - Test Support Profile (TSP)
Annex D (normative) - Measurement of BER and FER
Annex E (informative) - Procedures for the measurement of
synchronization loss at the EUT by the LT
Annex F (informative) - Guide lines for installation
related issues
History
Describes tests applicable to all Digital Enhanced Cordless Telecommunications (DECT) equipment accessing the DECT frequency band 1880 MHz to 1900 MHz (including provisions for testing other or extended frequency bands as described in ETSI EN 300 175-1 and ETSI EN 300 175-2).
Published | |
Document Type | Standard |
Status | Current |
Publisher | European Telecommunications Standards Institute |
Pages | |
ISBN | |
Committee | DECT |
Supersedes |
|