Table of Contents

FOREWORD
PREFACE
INTRODUCTION
SECTION ONE - GENERAL
Clause
1. Scope
2. Object
3. Terminology
4. General note on interference caused by radio
    transmitters
5. Radiation hazard
SECTION TWO - RADIATION TEST SITE TEST CONDITIONS
AND MEASURING EQUIPMENT
6. Radiation test site
7. Measuring equipment
8. General test conditions
SECTION THREE - SMALL TRANSMITTERS
9. Application
10. Arrangement of the transmitter
11. Arrangement of the test load and power supply
12. Method of measurement
13. Presentation of the results
SECTION FOUR - MEDIUM-SIZED TRANSMITTERS
(Under consideration)
SECTION FIVE - LARGE TRANSMITTERS
(Under consideration)

Abstract

244-7A FIRST SUPPLEMENT 1980 Specifies the method which is essentially the same as that described in CISPR Publication 11, sub-clause 5.2.2. With this method, emphasis has been laid on simplicity and reproducibility, rather than on rigorous scientific method. It has been purposely developed for use in an ordinary laboratory room to avoid the use of an expensive anechoic room. The method is intended for type tests but it may be used for acceptance tests and factory tests. The standard is intended to be used in conjunction with Publication 244-6.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	SC 12C