Table of Contents

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Additional requirements for the repair and overhaul
   of equipment with type of protection 'd' (flameproof)
6 Additional requirements for the repair and overhaul
   of equipment with type of protection 'i' (intrinsic safety)
7 Additional requirements for the repair and overhaul
   of equipment with type of protection 'p' (pressurized)
8 Additional requirements for the repair and overhaul
   of equipment with type of protection 'e' (increased safety)
9 Additional requirements for the repair and overhaul
   of equipment with type of protection 'n'
10 Additional requirements for the repair and overhaul
   of equipment covered by IEC 60079-26
11 Additional requirements for the repair and overhaul
   of equipment with type of protection Group III 't' (formerly
   known as 'tD' or DIP)
12 Additional requirements for the repair and overhaul of
   equipment with type of protection pressurization 'pD'
Annex A (normative) - Identification of repaired equipment
        by marking
Annex B (normative) - Knowledge, skills and competencies of
        'responsible persons' and 'operatives'
Annex C (normative) - Requirements for measurements in
        flameproof equipment during overhaul, repair and
        reclamation (including guidance on tolerances)
Annex D (informative)
Bibliography

Abstract

Provides instructions, principally of a technical nature, on the repair, overhaul, reclamation and modification of equipment designed for use in explosive atmospheres.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 31