Table of Contents

FOREWORD
INTRODUCTION
Clause
1 Scope
2 Normative references
3 Dimensions
  3.1 Connection dimensions at the differential
      pressure (type) instrument
  3.2 Connection dimensions at the shut-off device
  3.3 Seal rings
  3.4 Flange connection (see figures 4 and 5)
4 Installation
5 Material for the bolts
6 Marking

Abstract

Applies differential pressure (type) measuring instruments (instrument) with a shut-off device (manifold) directly bolted on to them. It specifies mating dimensions and tolerances, threads, bolts, and gaskets for a maximum allowable working pressure of 41,3 MPa (413 bar) at 38 deg C. This Standard does not apply to assemblies that provide additional sealing elements (adapters) between the instrument and the manifold. This Standard is only valid for instrument and manifold flanges manufactured from a metallic material with yield strength equal to , or larger than, 190 N/mm2

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	SC 65B