Table of Contents

FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references<br>3 Terms and definitions<br>4 General requirements<br>5 General notes on tests<br>6 Classification<br>7 Marking<br>8 Protection against accidental contact with live parts<br>9 Terminals<br>10 Provisions for earthing<br>11 Moisture resistance and insulation<br>12 Electric strength<br>13 Thermal endurance test for windings<br>14 Electromagnetic controlgear heating<br>15 High-voltage impulse testing<br>16 Fault conditions<br>17 Construction<br>18 Creepage distances and clearances<br>19 Screws, current-carrying parts and connections<br>20 Resistance to heat, fire and tracking<br>21 Resistance to corrosion<br>22 No-load output voltage<br>Annex A (normative) - Test to establish whether a<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;conductive part is a live part which may<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;cause an electric shock<br>Annex B (normative) - Particular requirements for<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;thermally protected lamp electromagnetic <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;controlgear<br>Annex C (normative) - Particular requirements <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;for electronic lamp controlgear with<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;means of protection against overheating<br>Annex D (normative) - Requirements for carrying <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;out the heating tests of thermally protected <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;lamp electromagnetic controlgear <br>Annex E (normative) - Use of constant S other <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;than 4500 in t[w] tests<br>Annex F (normative) - Draught-proof enclosure <br>Annex G (normative) - Explanation of the derivation <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;of the values of pulse voltages <br>Annex H (normative) - Tests<br>Annex I (normative) - Method for selection of varistors<br>Annex J (informative) - Explanation of electromagnetic <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;controlgear temperatures <br>Annex K (normative) - Additional requirements for <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;built-in electromagnetic controlgear with <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;double or reinforced insulation<br>Bibliography

Abstract

Defines particular safety requirements for electromagnetic controlgear for discharge lamps such as high-pressure mercury vapour, low-pressure sodium vapour, high-pressure sodium vapour and metal halide lamps.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 34